FAQs
If there are questions that are not answered by the FAQs below, please contact us.
CutRight does not launch after installation. What is wrong?
This is most likely due to the installer not gaining administrator rights during installation. Go to C:\CutRight\bin and run register.bat as an administrator (right click on register.bat and run as administrator). CutRight should launch after the batch file finishes.
This is most likely due to the installer not gaining administrator rights during installation. Go to C:\CutRight\bin and run register.bat as an administrator (right click on register.bat and run as administrator). CutRight should launch after the batch file finishes.
What operating system does CutRight work on?
Windows (64-bit).
What 3D file formats does CutRight accept?
For now, CutRight only accepts STL file format as input.
Can CutRight simulate 5-axis milling?
Yes, CutRight 2.0 comes with full-fledged 5-axis simulation.
What G-code formats can CutRight read?
CutRight can read generic 3-axis, generic Fanuc 3-axis, generic HAAS 3-axis, generic MACH 3-axis, generic HURCO ISNC 3-axis, generic Okuma 3-axis, generic Siemens 3-axis and generic Tormach 3-axis G-code. Multiline is not currently supported.
Can CutRight run subprograms?
CutRight cannot currently run subprogams.
Can I append to a toolpath file within CutRight?
Yes, CutRight 2.0 has the ability to append/join as many toolpath files as you like. CutRight Lite, however, does not have this capability.
What end mills can CutRight support/simulate with?
Flat/square end mills, ball end mills, bull end mills, tapered end mills and tapered ball end mills.
Is there any way to import tools from a tool library?
For now, CutRight can only import and use tools created within the CutRight environment.